Clips on 1200cc or 1300cc

Depending upon the types of tools used to remove the covers installation will take about 5-10 minutes each.

Step 1:Remove the four 10mm bolts that hold the covers on.

You may leave one of the four bolts in and just swing the cover out of the way as pictured

IMAG0005

Step 2:Hook one side over the pin. Then press the other side on. Push WaveEater Clip into place by hand

steel_clip_011

Step 3:Gently push down on points indicated with red arrow with a screw driver tomake sure tabs secure the Alan Head screw

steel_clip_001

Step 4:Reinstall the covers, and your done. Make sure the cables are still on the pulley and adjusted per the manual’s specs

 

Repeat these steps for the rest of the valves

IMAG0013