Clips on 800cc

The 800cc engines require removing the exhaust to gain access to the power valve covers.


Step 1:Remove the four 10mm bolts that hold the covers on. You may leave one of the four bolts in and just swing the cover out of the way as pictured

Step 2:Hook one side over the pin. Then press the other side on. Push WaveEater Clip into place by hand

Step 3:Gently push down on points indicated with red arrow with a screw driver tomake sure tabs secure the Alan Head screw

Step 4:Reinstall the covers, and your done. Make sure the cables are still on the pulley and adjusted per the manual’s specs 

Repeat these steps for the rest of the valves